Cantek JEN-60, Operations & Parts Manual, Page: 12 / 37

11 DEC. 2019
Inspect Buffer pad and Alignment button if it is wear, it must be replacement
Check Drill Components for excessive wear.
Replace all safety and dust hoods if damaged.
Inspect the entire machine for damaged or broken parts.
Reconnect power supply and check operation.
Check buttons for smooth operation.
Inspect your buffer pad Surface periodically for wear; and if there is too
much clearance between the cutter and the notch in the fence surface, then
it should be replaced.
When installing a new buffer pad Surface, you should slow down the flow
control for your first cut. This will let the cutter make a nice clean cut in your
new buffer pad. When you are done, you can turn the flow control back to
the desired speed.
JEN60-130-32/Buffer pad(32mm)
JEN60-130-35/Buffer pad(35mm)
JEN60-130-38/Buffer pad(38mm)
JEN60-130-45/Buffer pad(45mm)
JEN60-130-51/Buffer pad(51mm)
JEN60-130-57/Buffer pad(57mm)
JEN60-260-32 /alignment button(32mm)
JEN60-260-35 /alignment button(35mm)
JEN60-260-38 /alignment button(38mm)
JEN60-260-45 /alignment button(45mm)
JEN60-260-51 /alignment button(51mm)
JEN60-260-57 /alignment button(57mm)