Quick Operation Guide of Digital Video Recorder
11
3.
Connect
pluggable block
back into terminal block.
RS-485 and Controller Connection
The rear pannel is vaious from different models, this picture is for reference only.
To connect PTZ to the DVR:
1.
Disconnect
pluggable block
from the RS-485 terminal block.
2.
Press and hold the orange part of the
pluggable block
; insert signal cables into slots and release the orange
part. Ensure signal cables are in tight.
3.
Connect A+ on PTZ to T+ on terminal block and B- on controller to T- on terminal block. Fasten stop
screws.
4.
Connect
pluggable block
back into terminal block.
To connect a controller to the DVR:
1.
Disconnect
pluggable block
from the KB terminal block.
2.
Press and hold the orange part of the
pluggable block
; insert signal cables into slots and release the orange
part. Ensure signal cables are in tight.
3.
Connect Ta on controller to D+ on terminal block and Tb on controller to D- on terminal block. Fasten stop
screws.
4.
Connect
pluggable block
back into terminal block.
Make sure both the controller and DVR are grounded.
Termination Switch Operation
The termination switch is placed on the mainboard instead of the rear panel. Open the upper cover and turn
on/off the SW switch if needed.
Purpose:
To connect the DVR with several speed domes, the bus topology can be adopted, which means the speed domes
