SmartLock
®
Pro
Page 22 of 29
Installation Manual
April 2009 • Rev. 1.7
ERASE CONTROLLER MEMORY, DIAGNOSTICS
1.
Disconnect communication and device wiring.
2.
To erase controller memory (factory default), set all switches to the
OFF
position (left on diagram above).
3.
Disconnect power from the board momentarily, then re-connect power.
4.
The controller’s memory will be erased. All three relays will cycle
ON
/
OFF
once the memory has been cleared. Relay outputs can be
verified during this stage.
NOTE
: If the relays do not cycle
ON
/
OFF
, there may be a problem
with the unit.
5.
Continue to set controller address and door contact bypass switch
settings.
NOTE:
Switch setting changes do not take effect until the power is
disconnected, then reconnected.
