CanProx Proximity/Keypad Reader
Installation Instructions
August 2018 • Rev. 1.6
Page 11 of 14
The interface board is designed to be used with Cansec’s P-640-HA, P-620-HA or P-640-
HA37, P-620-HA37 Proximity/Keypad Reader.
The Proximity/Keypad Reader is connected to the interface board which in turn is
connected to a regular Wiegand reader port on a Cansec or other manufacturer’s
controller.
In addition to operating in Card+PIN mode, the mode can be changed to Card Only
mode by opening the orange wire using a dry contact relay from an access control
system, a programmable timer, key-switch, etc. This allows, for example, the reader
operating mode to be set to Card Only during the day and Card+PIN off hours.
If the mode control circuit is connected to a relay which is managed by an access
system, the mode can be changed manually by the operator or in response to certain
events (subject to the capability of the access control system used). This could include
things such as time, date, specified input point in alarm, specified card used at selected
readers, etc.
