Cansec MAP1, Configuration

Page: 3 / 12

MAP1 IP Configuration Page 3 of 12
July 2021 • Rev. 1.2
Introduction
The MAP1 is factory set to DHCP mode when shipped and is recommended to leave it in
DHCP mode.
First Access software will automatically find all connected controllers in the
local network. The MAP1 controller can optionally be set to a static IP address. Cansec
provides a software utility called
MAP1 IP Configuration Tool which scans the network
for any connected MAP1 controllers and provides the option to change the IP addresses of
the MAP1 controllers. The utility is downloadable from cansec.com/downloads.
If there is no DHCP server present on the network, the
MAP1 IP Configuration Tool is
not applicable. However, the USB IP Configuration Tool can be used to configure the IP
addresses of the MAP1 controllers.
Note : The static IP address should be a valid address obtained from the IT department .
PC Requirements

All 32 and 64 bit versions of the following Windows Operating Systems: Windows 7
®
,
Windows 8
®
, Windows 10
®
, Windows 2008
®
, Windows 2012
®
and Windows 2016
®

See Microsoft’s web site for CPU, RAM and disk space requirements for the
aforementioned operating systems

Network adapter – If using MAP1 IP Configuration Tool

A computer USB port – If using USB IP Configuration Tool

A USB flash drive, formatted as FAT32 (most flash drives are formatted as FAT32) – If
using USB IP Configuration Tool

A text editor – If using USB IP Configuration Tool