81
Playback
During playback there is video noise.
- Video heads are dirty. Clean the video heads (
Playback does not start.
- Load a cassette (
- Set the camcorder to
(
- Tape reached the end (“
END” appears on the screen). Rewind the tape (
No sound from the built-in speaker.
- Open the LCD panel.
- Speaker volume is turned off. Adjust the volume with the [SPEAKER VOLUME] setting (
Image will not appear on the TV screen.
- Check again that the camcorder is properly connected to the TV (
Tape is running, but image will not appear on the TV screen.
- TV/VIDEO selector on the TV is not set to VIDEO. Set the selector to VIDEO (
- Video heads are dirty. Clean the video heads (
- You attempted to play back or dub a copyright protected tape (
65). Stop playback/dubbing.
Memory Card Operation
Memory card cannot be inserted.
- Memory card is not facing the correct direction. Turn the memory card over and reinsert it (
Cannot record on the memory card.
- Memory card is full. Erase still images (
54) to free some space or replace the memory card.
- Memory card was not initialized. Initialize the memory card (
- The folder and file numbers have reached their maximum value. Set [FILE NOS.] to [RESET] (
78) and
insert a new memory card.
Memory card cannot be played back.
- Set the camcorder to
(
Image cannot be erased.
- Image is protected. Cancel the protection (
- The write-protect switch on an SD or SDHC memory card is set to prevent accidental erasure. Change the
position of the write-protect switch.
flashes in red.
- A memory card error occurred. Turn off the camcorder. Remove and reinsert the memory card. Initialize the
memory card (
56) if flashing persists.
Printing
The printer is not operating even though the camcorder and printer are correctly connected.
- Disconnect the USB cable and turn off the camcorder and the printer. After a short while, turn them on again,
set the camcorder to
mode and restore the connection.
CO
PY