109
E
Editing
AUDIO
MONITOR
MIX
BALANCE
ST-1
ST-2
When you play back a tape that was recorded in 12-bit mode, you can set the audio output to
stereo 1 (the original sound), stereo 2 (any new sound, dubbed to the tape after recording), or mix
the balance between the two.
• Audio from the 16-bit mode only contains stereo 1 sound and so you cannot/do not need to
select the audio mix. The same applies to the 12-bit stereo 1 mode, unless new sound has been
added post-recording.
Select the output channel.
• Press AUDIO MONITOR on the wireless controller.
• Starting with the last selected setting, 4 settings appear as you push the button:
– STEREO1 for just stereo 1.
– STEREO2 for just stereo 2.
– MIX/FIXED for an equal mix of stereo 1 and 2.
– MIX/VARI. (mix variable) for when you want to mix the balance between stereo 1 and 2.
• If you choose MIX/VARI., you can go on to mix the balance.
• Use the ST-1/ST-2 buttons to mix the balance. A bar showing the balance appears on the
screen for 4 seconds.
Note:
• When you have chosen the output, STEREO1, STEREO2, MIX/FIXED or MIX/VARI. is shown in the
top left of the display for a few seconds. If you turn the power off, the output becomes set to
STEREO1.
+
PLAY
(VCR)
TAPE
Setting the Audio Mix
