Canon XF605, Instruction Manual

Page: 167 / 238

167
Configuring Connection S etting s
3 Select the network’s authentication method.
• If you select [Open System], select [Disable] (no encryption) and skip to step 6, or select [WEP] and continue
the procedure.
• If you select [Shared Key] or [Open System] > [WEP], select the key index.
4 Enter the password of the desired network and then select [OK].
• Enter the desired password using the keyboard screen (
A
27).
5 Set the IP address (
A
167).
6 Select [OK] to continue to configure the function settings.
• The communication settings are saved to an [NW] file.
• Continue with one the following procedures to configure the selected function’s settings.
FTP transfer (
A
161), IP streaming (
A
163), Browser Remote (
A
164), Canon App (
A
164)
Offline Configuration without Connecting to a Network
1 In the [Select a network] screen, select [Configure Offline].
2 Select the network type.
• If you select [Infrastructure], continue with the procedure to enter the SSID and authentication mode, from
step 2 (
A
166).
If you select [Camera Access Point Mode], continue from that procedure, from step 2 (
A
165).
Configuring the Camera’s IP Address
This section explains how to configure the IP address. Available settings will change depending on the network
function selected.
1 Select the method used to configure IPv4 settings, [Automatic Setting] or [Manual Setting].
• When using the wizard to add a new connection setting, make the selection in the [IP Address Settings
(IPv4)] screen.
• If you select [Automatic Setting], skip to step 4.
[Manual Setting]
2 Select [IP Address] and [Subnet Mask] and enter the desired addresses using the data entry screen (
A
27).
• To use a default gateway, select [Use Gateway] > [Enable] and then select [Gateway] and enter the address.
• To use a DNS address, select [Use DNS Address] > [Manual Setting] and enter the address.
3 Select [OK].
Both methods
4 Select whether to use TCP/IPv6 settings or not.
• To use IPv4 settings, select [Disable].
• To configure IPv6 settings (
A
170).
Other Network Setting s
Reading/Deleting a Root Certificate for FTP Transfer
When you use the [FTPS] transfer mode, you will need to read onto the camera the same root certificate saved
on the FTP server. You can also check the content of a previously loaded root certificate or delete it.
1 Set the camera to MEDIA mode.
2 Save the desired root certificate file onto the root directory of a card and insert it into card slot B.