Canon Saddle Finisher-T2, Service Manual

Page: 81 / 262

Chapter 2
2-49
After the processing tray paper sensor detects the paper, the aligning motor (M103/M104) starts and aligns the paper.
F-2-71
<Last Sheet>
When alignment of the last sheet completes, the finisher controller PCB moves the aligning plate to alignment
position with the aligning motor (M103/M104) (with the paper held with the aligning plate). Then the finisher
controller PCB staples at the specified staple position.
After stapling, the finisher controller PCB starts the swing motor (M106) and lowers the swing guide. Then the stack
is ejected by the stack delivery roller, return roller, and rear endassist guide.
F-2-72
2.4.5 Stitcher Unit
0009-2552
The stitcher base unit consists of two stitchers and stitcher bases.
The stitchers are fixed in position, and are not designed to slide or swing.
Stitching is executed by driving the rotary cam by the stitcher motor (M7, M6). The front and rear stitcher units are
operated with a time delay so as to prevent wrinkling of paper and to limit the load applied to the power supply. (A
Return roller
Processing tray
Stack ejection roller
1st delivery roller
Stapler
Swing guide
Return roller
Rear end assist guide
Stack ejection roller
Stapler
Swing guide