Canon Saddle Finisher-AF2, Service Manual

Page: 202 / 244

Chapter 5
5-40
F-5-186
7) Pressing switch SW383 [1] or SW384 [2] determines adjustment level.
By pressing SW383 once, the LED [3] indicates "-1" and the pressure
applied to the disengagement roller [1] is reduced (the disengagement
roller is moved in A direction).
In the same way, by pressing SW384 once, the LED [3] indicates "+1"
and the pressure applied to the disengagement roller [1] is increased (the
disengagement roller is moved in B direction).
- Adjustment range: -8 to +8 (0.3mm-change per unit)
F-5-187
F-5-188
<Reference>
As the plus adjustment value is specified, the feed performance improves.
8) Press switch SW385 [1] again to complete this adjustment.
F-5-189
9) Execute booklet print from the saddle and check that there is no displace-
ment in staple position.
5.3.2.27 Adjusting Feeding Distance of Saddle
Disengagement Roller
0021-1735
Execute this adjustment in the case of displacement in staple position.
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1] [2]
[3]
MEMO:
Executing this adjustment enables to extend feeding time of paper that is
executed before stapling (rotating time of M101 can be adjusted). With this
adjustment, there will be no abovementioned failure because this
adjustment can prevent insufficient feeding that is caused by slip of the
disengagement roller [1].
M102
[1]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]