Canon Oce VarioPrint 110, Service Manual

Page: 50 / 80

Océ VarioPrint 135/120/110 Service Guide
Océ VarioPrint 135/120/110 Service Guide January 2013
Revision 3 Page 44
higher start-up temperature, which increases the start-up time of the printer
and requires more time for the decomposition of the wax.
The more wax paper is printed using Wax Mode, the longer the printer needs
to decompose the wax. For optimal performance of the Wax Mode, do not
print more than 50,000 sheets of wax paper at a time. However, if more
printing is needed, allow the printer run in stand-by mode to decompose the
wax, or perform print jobs that do not require wax paper.
After processing wax paper, do not power off the machine manually or put the
machine into the sleep mode manually. Leave the printer in standby-mode to
allow the cleaning of the wax components. After maximum two (2) hours in
stand-by mode, the printer will switch to sleep mode automatically. If two (2)
hours are not enough to decompose all the wax, the machine will remain in
stand-by mode after the next job, until all the wax is cleaned.
When utilizing wax mode the TTF Drive Roller (Roller-Drive-Assembly-
Service, p/n 1060127357) must be replaced when replacing the Fuser Belt.
Q. Consumables
Consumables are all products and materials that are consumed with regular
use and cannot be reused. Such consumables include but are not limited to
paper, chemicals and toner.
A number of factors are considered when the approximate yield expectancy
of a consumable is determined, including paper size and the amount of
coverage per page.
Note: All consumables shown in the below table are estimates for reference
purposes only and are subject to change without notice. Actual usage may
vary.
Table 23 – Main Unit Consumables List
Description Part Number
6
Quantity
Estimated Life
(copies/prints
16
)
Remarks
VarioPrint DP-LINE Toner 6117B005AA 1 96,000
Each package
contains two (2)
toner bottles
(48,000
impressions per
bottle (at 6%
coverage)
VarioPrint DP-LINE DRUM
UNIT US
6013B001AA 1 8,000,000
IMPORTANT

Friction fed finishing is not recommended due to the risk of slight toner
abrasion.

When running certain applications, which contain large areas of heavy
coverage of solid black toner, you may observe some minor density
changes from lead edge to trail edge on the print.