Canon Macro ring lite MR-14EX II, Instruction Manual

Page: 34 / 260

32
You can set the flash output from 1/1 full output to 1/128 power in 1/3-
stop increments. The flash can be fired in one of the following three
ways: Flash tubes A and B fired at the same output, A and B fired at
different outputs, Only A or B fired.
Setting the camera’s shooting mode to <
f
> or <
a
> is
recommended. First, take a test shot to check the exposure.
1 Set the flash mode to <
q
>.
Press the <
E
> button and set to
<
q
>.
2
Turn off <
,
>.
Press the <
,
> button to turn off
<
,
>.
3 Set the flash output.
Press function button 2 <
@
> or
<
8
>.
X
The flash output level is highlighted.
Turn <
9
> to set the flash output,
then press <
8
>.
q
: Manual Flash
N
Firing Flash Tubes A and B at the Same Flash Output
If high-speed sync is set, the setting range will be 1/1 - 1/64.
The guide number will differ between both sides firing and single-side
firing even when the flash output settings are the same (p.75).
You can set the flash output directly by turning <
9
>, instead of pressing
the function button 2 <
@
> or <
8
> (C.Fn-13/p.63).
COP
Y