30 Positioning your projector
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 4 adjuster feet.
These adjusters change the image height and
projection angle. To adjust the projector, screw
the adjuster foot to fine tune the horizontal
angle.To retract the foot, screw the rear adjuster
foot in a reverse direction.
If the projector is not placed on a flat surface or
the screen and the projector are not parallel to
each other, the projected image becomes
trapezoidal. To correct this situation, see
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press
AUTO PC
.
Within 3 seconds, the built-in Intelligent Auto Adjustment function will re-adjust the values of
Frequency and Clock to provide the best picture quality.
The current source information will be displayed in the corner of the screen for 3 seconds.
Fine-tuning the image size and clarity
Do not look into the lens while the light source is on. The strong light from the light source may
cause damage to your eyes.
This function is only available when PC signal (analog RGB) is selected.
1. Adjust the projected image to the size that
you need using the zoom ring.
2. Sharpen the image by rotating the focus
ring.
Allow a 30 min. warm up before focus adjustment, if possible. Immediately after startup, the heat
of the light source may prevent stable focus. (Page
)