Canon LV-7545U, Service Manual

Page: 44 / 130

Part 2: Repair Information
2-19
7. LAMP REPLACEMENT
Replacement Procedure
1. Turn off the projector and disconnect the AC
cord.
2. Remove 2 screw with a Phillips screwdriver and
remove the lamp cover.
3. Remove 2 screws and pull out the lamp
assembly by grasping the handle.
4. Install the new lamp assembly securely and
tighten 2 screws.
5. Place the lamp cover and tighten 2 screws.
6. Connect the AC cord to the projector and turn
on.
7. Reset the lamp replacement monitor timer. See
the explanation below.
How to reset the lamp replacement monitor timer
1. Turn the projector on, and press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGH buttons to position the pointer at the setting
menu icon.
2. Press the POINT DOWN button. Move the pointer to the menu and position it at the
"Lamp Counter Reset" icon, then press the SET button.
3. The message "Lamp Counter Reset?" is displayed. Press the POINT UP/DOWN
buttons to position the pointer at [Yes] and press the SET button to select it.
Please refer to the owners manual for further information.
Recommendation
Should the air filter become clogged with dust particles, it will reduce the cooling fan's
effectiveness and may result in internal heat build up and short lamp life. We
recommend cleaning the air filter after the projection lamp is replaced.
Refer to "Air Filter Cleaning".
• For continued safety, replace with a lamp assembly of the same type.
Service Parts No.: DY4-6319-000 (LV-LP13)
• Allow the projector to cool for at least 45 minutes before you open the
lamp cover. The inside of the projector can become very hot.
• Do not drop the lamp module or touch the glass bulb! The glass can
shatter and cause injury.
WARNING
Do not reset the Lamp
Replacement Monitor Timer,
except after the lamp is
replaced.
CAUTION
Fig. 2-26
Lamp cover
Lamp Assembly
Handle
Screw