Canon iR1018, Installation Procedure

Page: 16 / 20

Chapter 1
8
When tightening the screws, take care not to damage
the repeating harness A.
11) Slide the card reader cover [1] to attach it to the
card reader mount.
F-1-17
Route the repeating wire A [1] as shown below.
F-1-18
12) Using the supplied binding screw (M4x6)[1], se-
cure the card reader cover [2].
F-1-19
13) Connect the connector of the repeating harness A
[1] to the connector J317 [2] on the image processor
PCB.
F-1-20
14) Form the repeating harness A [1] into four loops
with a diameter of about 4 cm (B), and then bind
them with the supplied reuse band [2]. Cut out the
excessive portion of the band.
F-1-21
15) Route the bound repeating harness [1] as shown,
and secure the reuse band [2] to the host machine.
[1]
[1]
[1]
[2]
[2] [1]
[1]
[2]
B