Canon iPR C7010VP Series, Installation Manual

Page: 46 / 157

Chapter 2
2-1
2.1 Main Body
2.1.1 Process Unit
2.1.1.1 Developing Rail Unit (9 million prints)
0026-4429 imagePRESS C6010 / imagePRESS C7010VP / imag ePRESS C6010VP /
imagePRESS C7010VP FS / imageP RESS C7010VP PSU / imagePRESS
C6010VP FS / imagePRESS C6010VP PSU / imagePRESS C6010 FS / im-
agePRESS C6010 PSU
1. Parts to replace
- Developing input gear (FU6-0368)
- Developing cylinder one-way gear (FU6-0369)
- Developing drive shaft (FM2-2107)
2. Before the replacement
1) Remove the Developing Assembly. Refer to "Chapter 7 Remov ing the
Developing Assembly" in the Service Manual.
2) Remove the Process Unit. Refer to "Chapter 7 Removing the Developing
Assembly" in the Service Manual.
3. Replacement procedure
1) Remove the plate [1], Shaft Support [2], and washer [3].
- 2 Screws [4]
F-2-1
2) Remove the developing input gear [1], the developing cylinder one-way
gear [2] and the developing drive shaft [3].
- 4 E-rings [4]
- 1 parallel pin [5]
- 3 washers [6]
- 1 bearing [7]
F-2-2
2.1.1.2 Developing Drive Unit (9 million prints)
0026-4430
imagePRESS C6010 / im agePRESS C7010VP / imagePRESS C60 10VP /
imagePRESS C7010VP FS / image PRESS C7010VP PSU / imagePRE SS
C6010VP FS / imagePRESS C6010VP PSU / imagePRESS C6010 FS / im-
agePRESS C6010 PSU
1. Parts to replace
- Developing drive unit (FM4-2573) [1]
2. Before the replacement
1) Execute the following in Service Mode to discharge the waste toner (du-
ration:approximately 5 min.)
COPIER > FUNCTION > MISC-P > WTNR-ALL
2) Pull out the Developing Assembly for each color for more than 100 mm.
(To disen gage th e Developing Ass embly from the Developing Waste
Toner Connecting Pipe.)
3) Disconnect the Power Unit Station from the Main Station. Refer to "Chap-
ter 10 Disconnecting the Power Unit Station" in the Service Manual.
4) Remove the Main Station Rear Left Cover. Refer to "Chapter 10 Remov-
ing the Main Station Rear Left Cover" in the Service Manual.
5) Remove the Main Station Rear Right Cover. Refer to "Chapter 10 Remov-
ing the Main Station Rear Right Cover" in the Service Manual.
CAUTION: Points to note when exhausting the waste toner
When exhausting the waste toner, be sure to place the waste toner container
in the waste toner storage.
[1]
[2]
[3]
[4]
[4]
[4]
[4]
[5]
[6]
[6]
[6]
[7]