Canon iPF671, Service Manual

Page: 179 / 312

Chapter 4
4-43
4.3.12 Multi Sensor
0032-0595
a) Removing the Multi Sensor
1) Unlock the carriage unit, and then move the carriage onto the platen. Refer to "Disassembly/Reassembly > Points to Note on Disassembly and Reassembly >
Opening the Cap/Moving the Wiper Unit".
2) Remove the printhead to protect it.
3) Remove one screw [1] and disconnect one connector [2], and then the multi sensor [3].
F-4-100
b) Removing the Multi Sensor Reference Plate
1) Remove one screw [1], and then remove the multi sensor reference plate [2].
F-4-101
Do not touch the white sheets of the multi sensor reference plate.
c) Action following the replacement of the carriage unit/multi sensor
Because the distance between the multi sensor (in the carriage unit) and the nozzles (in the printhead) is varied from one unit to another, the printer as shipped has
its optical axis corrected to adjust the image write position. When the carriage unit or multi sensor has been replaced or disassembled and reassembled, they require
adjustment.
Execute service mode under the following conditions:
* The multi sensor reference plate(QL2-6891: MOUNT, MULTI SENSOR REFERENCE) must be replaced at the same time whenever the carriage or the multi
sensor is being replaced.
1) Carry out the following service mode without media loading.
- Service mode : SERVICE MODE > ADJUST > GAP CALIB.
2) Load the following media.
Media type : Photo glossy paper
Media size : Media having a width equal toor larger then that of A2-size paper
3) Carry out the following service mode.
- Service mode : SERVICE MODE > ADJUST > PRINT PATTERN > OPTICAL AXIS
[1] [3]
[2]
[1] [2]