Canon Inner Finisher-H1, Service Manual

Page: 39 / 108

Jam Detection
Outline
The finisher is equipped with the following paper detection sensor to check whether paper is present and whether the stapler is
operating normally.
Further, it is equipped with the following switch to detect the open or closed state of the front cover.
• Delivery Sensor (PS1)
• Front Cover Switch (MSW1)
PS1
MSW1
Occurrence of a jam is checked (at the check timing) according to the sensor and switch detection states stored in the CPU (IC1)
on the finisher controller PCB.
When the finisher controller PCB judges that a jam has occurred, it stops feeding/delivering paper and notifies occurrence of the
jam to the host machine.
Jam code Jam type Sensor Jam description
1001 Delivery sensor delay jam PS1 The delivery sensor (PS1) does not detect paper even when
the specified time has elapsed after receiving a paper re-
ception notification signal from the host machine.
1101 Delivery sensor stationary jam PS1 The delivery sensor does not turn off even when the speci-
fied time has elapsed after the delivery sensor (PS1) detects
paper.
1200 Early timing jam - The next paper reception notification signal is detected ear-
lier than the specified time after the previous paper reception
notification signal is received from the host machine.
1301 Power-on jam PS1 The delivery sensor (PS1) detects paper during power-on or
after recovering from sleep mode.
1400 Door open jam MSW1 The front cover switch (MSW1) detects that the front cover
has been opened during operation.
1500 Stapler staple jam - The staple HP sensor cannot detect the stapler even after
the specified time has elapsed since the stapler passed
through the staple HP sensor when stapling is executed.
1701 Warm-up rotation jam PS1 The delivery sensor (PS1) detects paper during warm-up ro-
tation.
1801 Staple-free staple jam - Clinch motor drive detection sensor error:
The clinch motor drive detection sensor (PS13) cannot de-
tect clock pulses even after the clinch motor (M9) is driven
for a given time.
1802 Clinch HP sensor error:
The clinch HP sensor (PS15) does not turn on even after the
clinch motor (M9) is driven for 0.25 seconds.
1803 Clinch motor error:
The clinch motor drive detection sensor (PS13) cannot de-
tect clock pulses even after the clinch motor (M9) is driven
for 0.24 to 0.25 seconds.And, the clinch HP sensor (PS15)
does not turn on even after the clinch motor (M9) is driven
for 0.25 seconds.
2. Technical Explanation
33