Canon imageRUNNER C3125i, User Manual

Page: 41 / 816

If you do not want to use DHCP/BOOTP/RARP to assign an IP address
● Select <Off>. If you select <DHCP> when these services are unavailable, the machine will waste time
and communications resources searching the network for these services.
4
Check that <Auto IP> is set to <On>.
● If <Off> is selected, change the setting to <On>.
5
Select <Apply>.
● IP addresses assigned via DHCP override the address obtained via Auto IP.
Manually entering an IP address
1
Select <Auto Acquire>, and select <Off> <Apply> in <IP Address Settings (Auto Acquire)>.
2
Select <Manually Acquire>.
3
Enter <IP Address>, <Subnet Mask>, and <Gateway Address>, and select <Apply>.
5
Restart the machine.
● Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
Checking whether the settings are correct
● Make sure that the Remote UI screen can be displayed with your computer ( Starting Remote
UI(P. 436) ). If a computer is not available, you can check the connection by using the operation panel (
Testing the Network Connection(P. 32) ).
When you have changed the IP address after installing the printer driver
● When the MFNP port is used, the connection is maintained as long as the machine and the computer belong
to the same subnet; therefore, you do not need to add a new port. When the standard TCP/IP port is used,
you need to add a new port. Configuring Printer Ports(P. 43)
*
If you do not know which port is used, see Checking the Printer Port(P. 799) .
Testing the Network Connection
1
Select <Menu> in the Home screen. Home Screen(P. 117)
2
Select <Preferences> <Network>.
● If the login screen appears, enter the correct ID and PIN. Logging in to the Machine(P. 128)
3
Select <TCP/IP Settings> <IPv4 Settings> <PING Command>.
Setting Up
32