Check not only visually but also by grasping the waste toner gear holder to confirm that it does not rattle.
Install the removed waste toner gear holder as follows:
1) Insert the boss[a] on the upper part of the waste toner gear holder into the mounting hole[A] of the main unit, and fix the claw[b]
by hooking it on the edge of the plate[B].
2) Install the waste toner gear holder by fitting the boss holes[c] on the lower part of the waste toner gear holder with the bosses[C]
of the main unit.
[Caution] Fig.[A] shows the state where the bosses are fitted deeply [a] and normally installed. Fig.[B] shows the state where the
bosses are fitted shallowly [b] and installed insufficiently.
F00693-EN-4.00
2 of 6