Measures when DADF does not open
[Symptom]
DADF installed in the machine may not be opened since the magnet is not separated even if the handle of DADF is gripped.
[Cause]
If the attaching section of the handle shaft [B] is broken, the shaft does not turn even if the handle is gripped. Therefore, the
magnet attached to the shaft does not separate from the supporting plate on the copy board side, resulting in the above-mentioned
symptom.
Photo [A] shows the handle attached correctly, and photo [B] shows the handle with the shaft mounting section broken.
[Remedy]
Prepare the ADF handle set (FM1-V005-000) [1] that was set up exclusively as a service part, and replace the handle and the
shaft by following the procedure below.
The handle (x1), shaft (x1) and screws (x2) are included in the ADF handle set (FM1-V005-000) [1].
1) Refer to Service Manual "4. Parts Replacement and Cleaning > Original Exposure and Feed System > External Auxiliary
System (DADF), Removing the DADF Front Cover" and remove the DADF front cover.
2) Remove the screws (x2) and remove the handle [1] from the shaft. Then the spring [2] inserted between the handle and the
base frame is detached, and remove the spring carefully.
36
Summary of Contents for imageRUNNER ADVANCE 6500 series
