Canon imageRUNNER 2545i, Sending And Facsimile Manual

Page: 182 / 321

Advanced Receiving Methods 5-7
R
e
c
e
iving Documents
5
Receiving Documents in Memory without Printing Out
(Memory Lock)
Normally a document is printed as soon as you receive it. However, there may be
occasions when you want the machine to store all documents in memory until you
are ready to print them. Locking the machine to receive and store all documents in
memory is called Memory Lock.
To use this feature, see Chapter 4, “Setting the Send Function,” in the System
Settings Guide .
IMPORTANT
•
Additional documents cannot be received in memory in any of the following cases (the
numbers below may vary depending on the remaining capacity of memory):
- When a total of 95 documents (75 documents if only I-fax documents are stored)
have been stored in memory
- When a total of approximately 1,000 pages have been stored in memory
- When a total of 90 received documents or 99 report jobs are waiting to be printed
while the machine is out of paper.
•
Even if a blackout occurs or the machine is turned OFF, a built-in battery retains the
documents received in memory for about an hour. However, if the battery is not fully
charged, the documents may not be retained. (To fully charge the built-in battery, it
takes about two hours after the main power switch is turned ON.)
NOTE
The System Monitor screen enables you to check, delete, and forward documents
received in memory. (See “Checking/Changing the Status of Documents Received in
Memory,” on p. 6-14.)
Memory
Print
S end
I-Fax Reception
Fax Reception