![background image](http://html.mh-extra.com/html/canon/imageformula-dr-m160/imageformula-dr-m160_service-manual_62983054.webp)
3-12
COPYRIGHT
©
CANON ELECTRONICS INC. 2011 CANON DR-M160 FIRST EDITION
CHAPTER 3 DISASSEMBLY & REASSEMBLY
6. Lower Feed Guide Plate
1) Remove the lower reading unit.
2)
Remove the 4 screws
{
1
(M3,
Figure 3-308b
3) Remove the wire bundle guide.
(Page 3-11)
4) Remove the main motor.
(Page 3-10)
5) Open the front unit, unhook the 3 pairs of
fitting parts
{
1
at the bottom, and then
push the plate out slightly. Next, unhook
the 2 pairs of fitting parts
{
2
in the
center in the direction shown in the
below figure, and push the plate out
slightly towards the front. Next, unhook
the 2 pairs of fitting parts
{
3
at the top
and remove the lower feed guide plate
{
4
. You should completely detach the
fitting parts.
Note:
For the fitting parts on the bottom side,
unhook the left and right fitting parts by
pushing while bending the plate
downwards, and unhook the central fitting
part by pushing while bending upwards.
Note:
You should close the roller cover before
removing the fitting parts in the center.
Figure 3-309
Notes on assembling
All of the fitting parts should be fully
seated. There should not be any raised
parts.
If the guide plate has been deformed too
much and does not return to its original
shape and affects feeding, either repair
it or replace it with a new part.
You should mount the center fitting parts
of the guide plate so that it sticks out
slightly from the gap on the bottom side
when the roller cover is closed.
①