10
1
The paper starts feeding, and then the
printer automatically starts charging the
system with ink and adjusting the print
head. Charging the system with ink and
adjusting the print head for the first time
takes about 45 minutes.
Important
• Do not open the covers of the printer
or turn the power off while the ink is
charging for the first time and the print
head adjustment is executing.
Note
• Charging the system with ink fills the
system from the ink tanks to the print
head. In addition, cleaning is performed
to keep the printer in optimal condition.
This may cause the remaining ink
indicator and maintenance cartridge
capacity indicator to drop some amount.
The starter ink tank is for first-time
installation. It is recommended that you
purchase replacement ink tanks quickly.
2
Once a single sheet of the adjustment
pattern has finished printing, lift up the
release lever and remove the paper for
adjustment.
3
Check the screen.
When a screen for selecting the
connection method is displayed
Proceed directly to step 4.
When a screen prompting you to add
paper is displayed
Load the second sheet of paper by
referring to steps 2 to 5 on p.9.
4
Once the print head adjustment has
finished, the screen below appears.
Tap the connection method to use.
Check the message about the connection
method and tap
Yes
if there are no
problems.
USB connection
This is the method for connecting the printer to a computer using a USB cable.
Only 1 printer can be connected.
Do not connect the USB cable yet.
Wired LAN connection
This is the method for connecting the printer to the network using a LAN cable.
Wireless LAN connection
This is the method for connecting the printer to the network without using a cable.
5
If you selected
USB connection
Proceed to "Connect to the Printer" on
p.12.
If you selected
Wired LAN connection
Use the LAN cable to connect the
wired LAN connector on the back of
the printer to the hub port.
Tap
OK
, and then proceed to "Connect
to the Printer" on p.12.
If you selected
Wireless LAN connection
To configure the wireless LAN settings using a computer, tap
Yes
, or to configure the wireless
LAN settings on the printer, tap
No
, and proceed to "Connect to the Printer" on p.12.
If you selected
Do not connect
Setup has finished at this point.
However, the connection settings and
software installation will need to be
performed separately in order to use the
printer from a computer.
(Refer to "Connect to the Printer" on p.12)
Perform Print Head Adjustment and Select the Connection Method
(on the PRO-2000)
To load roll paper after setup, tap the paper settings display area from the home screen, then (roll paper icon), then
Replace paper
, and follow the
instructions on the screen.
For details, refer to the Online Manual that can be accessed by the procedure in "How to Display the Online Manuals" (p.14).
