Cause
Corrective Action
Paper has been loaded
askew, or warped paper
has been loaded.
(See "Loading Rolls in the Printer.")
➔
P.15
2.
Pull the Release Lever forward.
3.
If "
Not finished printing. Finish printing remaining jobs?
" is shown on the Display Screen, press
the
OK
button.
Printing will resume, starting from the page on which the error occurred.
If this error recurs after you reload the roll, remove the Roll Holder from the printer, push the roll firmly in
until it touches the Roll Holder flange, and reload the Roll Holder in the printer.
(See "Attaching the Roll Holder to Rolls.")
➔
P.12
Follow these step to reload a sheet.
1.
Push the Release Lever back.
2.
Load the sheet, aligning it with the guide on the right.
(See "Loading Sheets in the Printer.")
➔
P.21
3.
Pull the Release Lever forward.
4.
If "
Not finished printing. Finish printing remaining jobs?
" is shown on the Display Screen, press
the
OK
button.
Printing will resume, starting from the page on which the error occurred.
Insufficient paper for job
Insufficient paper for job
Cause
Corrective Action
The printer has received a print job longer than the amount of roll paper left when
Man-
ageRemainRoll
in the Control Panel menu is
On
.
Press
▲
or
▼
to select
, and then
press the
OK
button to resume printing.
However, the roll paper may run out dur-
ing the print job and you may not be
able to print all of the document.
Press
▲
or
▼
to select
Change Paper
,
and then press the
OK
button to stop
printing.
Either change the printer driver
Paper
Source
setting or the
GL2 Settings
>
Paper Source
setting in the printer
menu or replace the roll with a roll that
has enough paper for the print job, and
then try printing again.
(See "Removing the Roll from the Print-
er.")
➔
P.18
(See "Loading Rolls in the Print-
er.")
➔
P.15
Press
▲
or
▼
and select
Stop Printing
or press the
Stop
button to stop printing.
This paper cannot be used.
This paper cannot be used.
Cause
Corrective Action
Paper smaller than the printer's minimum suppor-
ted size has been loaded.
Push the Release Lever back and load paper of the correct size.
(See "Paper Sizes.")
➔
User's Guide
Paper has been loaded that is too small to print
the test pattern for printhead adjustment or noz-
zle checking.
Push the Release Lever back and load unused paper of A4 size or larger. More
than one sheet may be required depending on the adjustment.
iPF685 Series
Insufficient paper for job
Basic Guide
Error Message
Messages regarding paper
115
