Canon HJ14EX4.3B IRSE, Operation Manual

Page: 43 / 114

E9
3 HOW TO MOUNT
3-2. MOUNT THE LENS ON THE CAMERA
Before mounting the lens on the camera, make sure that the camera’s power is turned off.
1
Position the camera horizontally.
↓
2
Turn the bayonet mount ring of the camera
counterclockwise as viewed from the lens.
Remove the dust cap from the camera mount.
↓
3
Remove the dust cap from the lens.
↓
4
Align the locating pin on the lens mount with the
slot on the camera mount and fit the lens into the
camera mount surface.
↓
5
Turn the bayonet mount ring clockwise until the
lens mount is firmly fixed in place.
↓
6
Connect the power/iris control cable on the back
of the drive unit to the appropriate receptacle on
the camera head.
* For ITS-RE type lenses
Connect an optional extension cable to the lens
control cable if needed. Then connect the cable
to the optional remote controller.
CAUTION
Never hold the lens, drive unit and band portion to
support the entire weight of the camera. Excessive
force to the mount portion and drive unit of the
lens may result in damage to the lens mechanism.
NOTE
1. Once they have been removed, keep the caps
in a safe place so that they will not be lost or
misplaced.
2. A master key mark is provided on the power/
iris control cable. Connection can be performed
smoothly by aligning the master key mark on the
camera connector with this mark.
3. Depending on systems, it is required to check the
camera's specification.
Power/Iris control cable
Control cable
Locating pin
Bayonet mount ring
Camera