Canon Finisher-R1, Service Manual

Page: 64 / 177

Chapter 3
3-12
front cover. In the case of the Finisher-R1, do not
attach the front cover until you have adjusted the
height/tilt.
3.2.2.4 Checking the Height/
Tilt
0003-1767
Depending on the condition of the floor of the site
of installation, you may need to adjust the height or
the tilt of the finisher. A discrepancy in the height
or tilt of the finisher can well lead to frequency
jams. Check the height/tilt as follows, and make
adjustments as necessary. (If you are installing a
puncher unit, be sure to make adjustments by
referring to the Puncher Unit Installation
Procedure.)
1) Check the height of the finisher and its host
machine. Check to make sure that the difference in
height between the top cover of the finisher and the
delivery cover of the host machine is 53±2 mm. Take
measurements at 2 locations at the front and the rear;
then, check to make sure that the difference between
the front and the rear is 1.5 mm or less.
F-3-29
2) Check the tilt of the finisher and its host machine.
Check to make sure that the gap between the upper
cover of the finisher and the delivery cover of the host
machine is 3±1.5 mm. Take measurements at 2
locations (front and rear), and check to make sure that
the gap at the front and the rear is 1.5 mm or less. Also,
check to be sure that the gap between the finisher and
its host machine is parallel from top to bottom when
viewed from the front.
53 2mm
53 2mm