Canon F-1, Service Manual

Page: 127 / 179

4
4
4-51
4-51
Parts Replacing and Cleaning > Consumable parts for periodical replacement and locations for cleaning (DADF) > Cleaning the Pullout Roller/Feed Roller 2/Lead Roller 1 > Procedure
Parts Replacing and Cleaning > Consumable parts for periodical replacement and locations for cleaning (DADF) > Cleaning the Pullout Roller/Feed Roller 2/Lead Roller 1 > Procedure
Cleaning the Post-separation Sensor 3
5) Clean the Post-separation Sensor 3 [1] by blowing air a couple of times through the
clearance [A] of the guide with a blower [2]. (When wiping it, be sure to use wet and tightly-
wrung lint-free paper.)
[1]
[2]
[A]
F-4-136
Cleaning the Pullout Roller/Feed Roller 2/Lead Roller 1
■ Procedure
CAUTION:
Be sure not to touch the surface of the roller when disassembling/assembling.
1) Open the Feeder Cover [1] and the Open/Close Guide Unit [2].
[1]
[2]
2) Remove the Scanner Unit Cover [1].
• 2 Screws [2]
• 1 Wire Saddle [3]
• 1 Connector [4]
x2
[1]
[1]
[2]
[2]
[3]
[4]
F-4-137
F-4-138