Canon Colorado 1650, Operation Manual

Page: 97 / 384

Load a media roll for inside printing
Introduction
You can load a media roll to print on the inside.
NOTE
• We recommend to use inside printing only in combination with a locked tension bar, see Print
and wind with a locked tension bar on page 132 .
• When you print on the inside both roll positions are used. You load the media roll at roll
position 2. You cannot use a second roll at position 1.
• You can use optional grip lock to insert the feed media shaft into the core of the new media
roll. You can load a media roll without the optional grip lock. This procedure describes both
situations.
Before you begin
Before you load a roll on the printer:
• Make sure you have added a media profile with the correct media type via the RIP. For more
information, see Print and wind with a tension bar on page 127 .
• Check the media size of your roll before loading. When your media size is not present in the list
on the operator panel, you can type it in.
• Put on gloves to avoid pollution of the paper by your fingerprints.
CAUTION
• Watch your fingers when you handle the media roll.
• Loading heavy media, 25 kg (55 lb) or more, has to be done by two people or with the help of
external lifting tools.
IMPORTANT
• Do not use dented or damaged media rolls to prevent damage to the printheads.
• Only open the media drawer when the indicator light on the drawer is on. Do not open the
drawer when the light is off, you can damage the machine.
Procedure
1. Pull firmly to open the media drawer.
2. Unload the media roll in position 1. For more information, see
Unload a media roll from the
drawer on page 159
.
Load a media roll for inside printing
Chapter 4 - Handle the media 97