Canon Colorado 1650, Operation Manual

Page: 132 / 384

Print and wind with a locked tension bar
Introduction
Winding media with a locked tension bar is only used for stiff media, in order to prevent media
transportation issues.
Before you begin
• The use of the tension bar is set in the media type configuration in the RIP software. For
winding with a locked tension bar, you must select [locked tension bar] under [Winding
tension]. For more information, see
Change the media settings on page 65
.
• Make sure you have placed a take-up roll core on the roll winder. For more information, see
Load a take-up roll core onto the roll winder on page 120
.
• Make sure you have tape ready.
• The printer is ready to print.
CAUTION
• Do not position the tension bar when there is no media present. Keep your fingers away
because the tension bar can fall down.
• The winder has an emergency stopping device; It is located on the winder. Activating this
emergency stopping device stops all winder motion.
Procedure
1. On the operator panel tap on the [Output] icon.
2. Tap on [Output configuration].
3. Make sure [Wind the output] is set to [Yes].
NOTE
Make sure you set the output configuration in time, as you cannot change the
configuration once the media has passed the clamp.
Print and wind with a locked tension bar
132 Chapter 4 - Handle the media