14
134910 Rev 1.
1.
(a)
(b)
A
2 N-m
M5x25
B
2.
5.
3.
5.
ENGLISH
TRIGGER/JEKYLL - OWNERS MANUAL SUPPLEMENT
‘
The rubber grommets
are pressed into the
frame holes when no
battery is installed.
Shimano Di2 Battery
Battery Installation
For Di2, use the seat post type battery
(Shimano SM-BTR2)
1. Remove fork and headset from the frame.
2. Attach mounting plate (1) included in Cannondale
kit
K32027/
to the battery (2) using two 3mm nylon
ties (3). Make sure the plate lip (a) is aligned with
the case groove on the battery nearer the cable
connection (b). See inset A.
3. Tie a thin dental string (5) to the battery plate
4. Plug in Di2 wire (to junction B) into the battery
5. Use a shift cable inserted into the top tube hole
and out the lower head tube to guide.
6. Attached the end of the dental thread to the shift
cable and draw the dental thread through and out
the top tube hole.
7. Insert the battery and plate in the bottom of the
head tube and use the dental thread to guide the
battery and plate into position. 5. With the battery
in position as shown, holding the string (5) taught,
apply grease to the screw (6) and tighten to 2 Nm.
The screw threads should cut the string so it can be
removed.
NOTICE
Periodically, check for proper tightness of the
mounting screws. Use a torque wrench. Do not
over-tighten.
Apply light
grease to
threads.
