11
134910 Rev 1.
M6
1.0 N-m
1.
a
M5
T25
5.0 N-m
2.
4.
3.
5mm
Eastwing.com
12oz/340g
NGLI-2
A
ENGLISH
TRIGGER/JEKYLL - OWNERS MANUAL SUPPLEMENT
Removal
The axle removal technique is shown removed from for
clarity. See inset A.
Steps:
A. Loosen the screw (4) 4-6 turns using a T25 Torx key.
B. Tap head of M4 screw (4) to un-seat threaded
wedge (2).
Remove M4 screw (4) and threaded wedge (2) from
the axle (1).
C. Insert a 5mm hex key to twist the wedge (3) free
and remove it (shown). If stuck, insert the long side
of a 6mm HEX key (non-ball end) from the threaded
end of axle and tap it out.
D. Insert a 6mm hex key into the axle and turn
counter-clockwise until it can be removed.
Installation
Be sure to inspect the parts for any burrs, scratches or
other damage before assembly. Replace the complete
axle assembly if any damage is found.
•
Apply a high-quality bearing grease to all the
parts of the assembly before installing into
the linkage. Be sure to coat all threads, wedge
surfaces and expansion areas.
•
Be sure to use the correct length axle and screw
for the specific location. See above.
•
Insert the axle (1) into the link from the non-drive
side. and tighten it with an 6mm hex to 1.0Nm.
Do not over-tighten.
•
Insert the threaded wedge (2) into the drive side
of the axle and insert the other wedge (3) and
screw (4) opposite and tighten screw with a T25
Torx to 5.0Nm.