6
7
130459.PDF
7
Installation
The following procedure should only be completed
by a professional bike mechanic.
For Loctite instructions:
http://tds.loctite.com/tds5/docs/638-EN.PDF
1. Remove old Loctite from the bearing bore and wipe the
bearing bore clean with alcohol.
2. Use a swab to apply a generous film of Loctite® 638™ to
the entire surface of the bearing bore.
3. Clean the outer bearing race of the bearing with a clean
shop towel dampened with alcohol.
4. Use the swab to apply a generous film of Loctite® 638™
to the surface of the outer bearing race.
5. Insert the bearing into the bore and press it in firmly until
it bottoms against the ridge at the bottom of the bore.
6. Wipe off excess Loctite™.
IMPORTANT:
The bearing must be seated against this
ridge until the Loctite cures. Allow the Loctite to cure
completely before attempting to continue assembly.
Allow at least 6 hours for Loctite to cure.
Allow at least 24 hours before riding.
NOTICE
Be careful to not damage the bearing
bore when cleaning.
130459_RUSH29_OMS_LAYERED_071813.indd 7
31.07.13 14:02
