english / deutsch / español / italiano / francais
4
5
MOUNTING THE WIRELESS SPEED SENSOR
1.
Pass the two cable ties through the sensor mounting holes and loosely mount to the
left fork leg using the rubber sensor mounting pad (do not fully tighten the cable ties
at this point). The sensor should be mounted as close to the top of the fork as possible
with the cap of the battery door toward the wheel. Make sure that the distance
between the sensor and the handlebars is no more than 24 in. (610mm).
2.
Loosely install the sensor magnet to one of the spokes of the front wheel. Adjust the
position of the magnet and sensor together so that the magnet is aligned with the
line on the bottom edge of the sensor and 1-2 mm separates the two parts and tighten
both parts in place. DO NOT over-tighten the magnet screw.
WARNING
:
Improper installation could lead to an accident, with risk of serious injury, paralysis or death. All
parts of the computer system must be securely attached to the bicycle in a way that prevents wires or other parts
from being caught in the wheels and avoids any conflict with the braking, steering or shifting controls. We urge
installation by a professional mechanic at a bicycle shop.
INSTALLING THE CYCLOCOMPUTER ON YOUR BIKE
2
INSTALLING THE CYCLOCOMPUTER ON YOUR BIKE
Cannondale IQ Series Cyclocomputers give you the option of mounting the computer on
your handle bars or stem.
MOUNTING THE HANDLEBAR/STEM BRACKET
1.
Place the Cyclocomputer unit into the mounting bracket and turn clockwise until the
unit snaps into place.
NOTE:
Do not over tighten.
2.
Place the mounting bracet in the desired position on handle bars or stem.
3.
Select the appropriate size rubber fastener (small
for handlebars, large for stem). Hook the rubber
fastener onto one side of the mounting sleeve.
Holding the fastener tightly, wrap the fastener
under the handle bars or stem and attatch to
other side of mounting sleeve.
1
2
3
1
