english / deutsch / español / italiano / francais
2
3
REPLACING THE BATTERY
Cannondale IQ118 Cyclocomputers use a CR2032 3v Lithium Battery in both the transmitter and the cyclocomputer
units. Under normal conditions, battery life should be approximately one year.
INSTALLING OR REPLACING THE COMPUTER BATTERY
1.
CYCLOCOMPUTER UNIT:
Using a coin or flathead screwdriver, turn the battery door counter
clockwise and remove the battery compartment cover.
TRANSMITTER UNIT:
Using a small phillips screwdriver, loosen the screws on each corner of
the battery compartment cover and remove the battery compartment cover.
2.
Carefully remove the old battery. Take care not to damage the O-ring seal.
3.
Place a new battery in the battery compartment with the positive (+) side facing the battery
compartment door.
CAUTION:
Do not bend the battery contact.
4.
CYCLOCOMPUTER UNIT:
Replace the battery compartment cover and tighten clockwise with a
coin or flathead screwdriver.
TRANSMITTER UNIT:
Replace the battery compartment cover and tighten the screws on each
corner of the battery compartment cover with a small flathead screwdriver.
ALWAYS
:
Check the batteries if you are experiencing problems with your computer. Most
problems with the operation of this unit are the result of dead or dying batteries.
WARNINGS & CAUTIONS
•
WARNING
:
Failure to pay attention to the road, trail, traffic or your surroundings could result in an accident, with
risk of serious injury, paralysis or death. You must focus on riding, not your computer. Learn computer operations,
and do all possible computer operations when not riding. For any operations you choose to perform while riding,
choose a time and place where this distraction has less risk.
•
CAUTION
:
Mount the Cyclocomputer according to the directions in this instruction manual.
•
CAUTION
:
Avoid direct impact to the Cyclocomputer unit.
•
CAUTION
:
Do not submerge the Cyclocomputer unit.
•
CAUTION
:
Avoid using the Cyclocomputer unit in or near strong electromagnetic fields such as high-voltage power
lines or other transmitters.
•
CAUTION
:
Do not disassemble the unit.
•
CAUTION
:
Make sure the magnet and the transmitter are well aligned and check them regularly.
•
CAUTION
:
Cannondale IQ Series Cyclocomputers are intended for use on bicycles only and should not be used on
any motorized vehicle.
• Change the battery prior to failure to avoid data loss.
• See your authorized Cannondale dealer if you have any trouble installing or maintaining your computer.
• Keep your computer in good shape and use it safely.
• Clean the unit with a mild detergent and a soft dry cloth. Never use any kind of solvent or alcohol.
