6
www.cannondownriggers.com
Installation
Arrows Indicate
Typical Mounting
Locations
Installing the Base on Your Boat
Decks up to 7/16” thick
Where access to the underside of the deck is not
available, the mounting base can be mounted using
wellnuts. Use the base as a template to mark locations
and drill four wellnut clearance holes. Mount the base
using four 1/4-20 x 1-1/2” truss head screws and four
wellnuts. Tighten the screws so the wellnuts are fi rmly
compressed as pictured.
Decks thicker than 7/16”
For decks thicker than 7/16”, or where the under-
side of the deck is accessible, mount the base with
screws, nuts, and washers. Use the base as a template
to mark the locations and drill four 9/32” holes. Use four
1/4-20 x 2” truss head screws and four each fl at wash-
ers and nuts. Fasten the base to the deck as pictured.
NOTE:
Wellnuts
SHOULD NOT
be used on decks
thicker than 7/16”.
Decks up to
7/16” Thick
Decks Thicker
Than 7/16”
Thick
Downrigger Mounting on Boats
A downrigger should be mounted wherever it is
easy to operate and observe. You want to be able to
see your fi shing rod and to react quickly. So, choosing
a good location to mount your downrigger on your boat
is very important.
Due to the great variety of boats available, mount-
ing your downrigger can be a diffi cult decision. Cannon
has a complete line of mounting and fi shing accesso-
ries to aid in your fi shing experience. Before making
any permanent changes to your boat consider what
accessories might be used in your application.
AnglingOutpost.com
1-888-356-5022
AnglingOutpost.com
1-888-356-5022
