ATTACHING THE CRANK HANDLE ASSEMBLY
........................................................................................................................................................................
Make sure the thrust bearing is sandwiched between its two races. The thrust bearing spring should be oriented
where the narrow end is toward the bearing. Slide the bearing with races and spring over the ratchet shaft. Then,
carefully thread the crank handle onto the shaft and continue turning the handle clockwise until the clutch is fully
tightened
NOTE:
Place your fi ngertip on the edge of the bearing and races. This allows the crank to be threaded more eas-
ily until the spring puts resistance on the clutch pad.
Installation
Races
Spring
Crank Handle
Thrust Bearing
