4
GB
•
Do not position
blinds behind the
cooker or less than 200
mm away from its
sides.
•
Any hoods must be
installed according to
the instructions listed in
the relevant operating
manual.
L
evelling
If it is necessary to level the
appliance, screw the
adjustable feet into the places
provided on each corner of the
base of the cooker (see
figure).
The legs* fit into the slots on
the underside of the base of
the cooker.
Electrical
connection
WARNING – THIS APPLIANCE MUST BE
EARTHED.
The appliance is designed to work with alternating
current at the supply voltage and frequency indicated
on the rating plate (situated on the rear part of the
appliance and on the last page of the instruction
booklet) or at the end of the instruction booklet. Make
sure that the local supply voltage corresponds to the
voltage indicated on the rating plate.
To connect directly to the mains supply, a double-
pole switch with a contact separation of at least 3
mm suitable for the load and complying with current
standards and regulations, must be fitted between
the appliance and the mains supply outlet. The
yellow-green earth wire must not be interrupted by
the switch. The supply cable must be in such a
position that no part of it can reach a temperature of
50 °C above room temperature. Do not use adapters
or shunts as they could cause heating or burning.
Before connecting to the power supply, make sure
that:
HOOD
900
Min.
mm.
420
Min.
min.
650
mm. with hood
min.
700
mm. without hood
mm.
420
Min.
mm.
• the limiter valve and the domestic system can
withstand the load from the appliance (
see rating
plate
);
• the supply system is efficiently earthed according
to standards and laws in force;
• the socket or double-pole switch are easily
accessible when the appliance is installed.
FAILURE TO OBSERVE THE ACCIDENT-
PREVENTION REGULATIONS RELIEVES THE
MANUFACTURER OF ALL LIABILITY.
Important:
the wires in the mains lead are coloured
in accordance with the following code:
Green & Yellow
- Earth
Blue
- Neutral
Brown
- Live
As the colours of the wires in the mains lead may not
correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
Connect the Green & Yellow wire to terminal marked
“
E
” or
or coloured Green or Green & Yellow.
Connect the Brown wire to the terminal marked “
L
” or
coloured Red.
Connect the Blue wire to the terminal marked “
N
” or
coloured Black.
Replacing the cable
Use a rubber cable of the type H05VV-F with a
suitable
cross section 3 x 2.5 mm².
The yellow-green earth wire must be 2-3 cm longer
than the other wires.
G
a
s
connection
Connection to the gas network or to the gas cylinder
may be carried out using a flexible rubber or steel hose,
in accordance with current national legislation and after
making sure that the appliance is suited to the type of
gas with which it will be supplied (see the rating sticker
on the cover: if this is not the case see below). When
using liquid gas from a cylinder, install a pressure
regulator which complies with current national
regulations. To make connection easier, the gas supply
may be turned sideways*: reverse the position of the
hose holder with that of the cap and replace the gasket
that is supplied with the appliance.
Check that the pressure of the gas supply is
consistent with the values indicated in the Table of
burner and nozzle specifications (see below). This
will ensure the safe operation and durability of your
appliance while maintaining efficient energy
consumption.
Summary of Contents for 90cm Free Standing Gas Cooker C90DPX
Page 18: ...18 GB...
Page 19: ...19 GB...