9
Opening the Door with the Keypad
If opening for the first time, the default a
ccess codes are ‘1234’ and ‘123456’.
Batteries must
be installed to work.
Enter the current one (1) to eight (8) digit code followed by the (
#
) button.
If the code is correct, the door will open automatically.
Note:
If the (*) button is pushed when entering the code, the process starts over.
If there are five (5) beeps with yellow LED flashes the code entered is not recognized as
the current code.
Lock Out (Wrong Try Penalty)
After ten (10) wrong entries the lock will go into lock out for three (3) minutes. Do not press any
buttons during the lockout period, it will restart the three (3) minute lock period.
Changing the Access Codes
To program your access codes, follow the instructions below:
Setting Main Code Number:
o
Open the door.
o
Press the
‘
RESET
’ button in the upper right corner of the inside of safe. System
will beep twice and yellow LED lights up.
o
Input the new one (1) to eight (8) digit code followed by the (*) button.
o
Your new code is now recorded.
Setting secondary code number:
o
Open the door.
o
Press the ‘
0
’ button twice (0-0) on the keypad.
o
Press the
‘
RESET
’ button in the upper right corner of the inside of safe. System
will beep twice and yellow LED lights up.
o
Input the new one (1) to eight (8) digit code followed by the (*) button.
o
Your new code is now recorded.
Note:
When entering the new code, the (*) button is not active.
Locking/Closing the Door
Slowly lift up on the bottom of the door.
Push upwards firmly until door lock engages.
