A. MANUFACTURER SAFETY INSTRUCTIONS
WARNING:
208-240 volts (single phase) may cause serious
injury from electric shock.
1. The working temperature of the dehumidifier is 60°F –100°F |
16°C-37°C
2. Installation and servicing should be conducted without
dehumidifier power. Leave the power disconnected until
installation/service is completed.
3. Do NOT roll, damage, or stress the power cord when installing
or moving the dehumidifier. It is dangerous to insert fingers or
any other objects into the dehumidifier. Do not attempt.
4. To avoid damage to the compressor, do NOT tilt the
dehumidifier more than 45°. If the dehumidifier is on an angle
during shipping or installation, ensure to let it sit upright 24
hours before applying power and starting.
5. Regarding the compressor: the room temperature will go
up around 3℃ from compressor heat dissipation when the
dehumidifier is running- this is typical and harmless.
6. The dehumidifier should never have direct contact with
chemicals and/or water. Place and situate the dehumidifier in
an area in which it will not have any contact with water and/or
chemicals.
7. Never connect other equipment to the dehumidifier: do NOT
use ANY relay, extension cords, or adapters to connect power
between the CAN-380, CAN-210, or any other dehumidifier.
8. Do NOT place the CAN-210 or CAN-380 dehumidifier next
to other equipment that will manipulate and deplete the
dehumidifier’s heat.
9. Clean any and all dirt or debris off the power cord before
inserting the plug.
10. Do not damage or modify the power line, do not repair by
yourself or disassemble and re-configure any parts in the
dehumidifier.
11. To attain a steady drain, ensure that the drainage tube has been
inserted smoothly in place.
12. In the case of malfunction, ALWAYS cut the power AFTER
shutting down the dehumidifier.
I N S T R U C T I O N M A N U A L 1 . 0
|
D E H U M I D I F I E R
|
C A N - 2 1 0 / C A N - 3 8 0
1
