Candy TRI 5, Instructions For Use And Installation

Page: 16 / 107

The water softener can treat water with a hardness level of up to 60°Fh (French grading) or 33°Dh (German grading) through 5 settings.
The settings are listed in the panel below:
Regulating the water softener with electronic programmer
Level
Water hardness
°fH (French)
Water hardness
°dH (German)
Use of regenerating
salt
Water softener
setting
2
4
4 no
yes
yes
yes
yes
USE
16 GB
WARNING!
If any problem occurs, turn thedishwasher off by pressing the "ON/OFF" button and start the procedure again from
the beginning (STEP 1).
1. Hold down the "PROGRAMME SELECTION" button and at the same time switch on the dishwasher by pressing the "ON/OFF"
button (a brief audible signal will sound).
2. Keep the "PROGRAMME SELECTION" button pressed for at least 5 seconds, UNTIL an audible signal sounds. Some "PRO-
GRAMME SELECTION" indicator lights will come on to indicate the current water softener setting level.
3. Press the same button again to select the required water softener level: each time the button is pressed, one indicator light will come
on (the water softener level is indicated by the number of lights on). For
level 5 , 4 lights will flash, for level 0 all lights will be off.
4. Turn off the dishwasher by pressing the "ON/OFF" button to confirm the new setting.
IMPORTANT
The dishwasher must ALWAYS be off before start of this procedure.
CONSUMPTION (main programmes)*
Power consumption of the off-mode and of the left-on mode: 0,5 W / 1 W
* Values are measured in a laboratory according to European Standard EN 60436 (consumption may
vary according to conditions of usage).
Programme
Universal
Eco
Rapid 32'
1,25
0.93
0.61
0,60
15
12
8
8
Energy (kWh) Water (L)
Information for the test laboratories General programme comparison
Ref. EN 60436 standards:
1) Normal load
2) Shine setting: "4"
3) Amount of detergent: 4 gr. for pre-wash, 10 gr. for whash.
WASHING PROGRAMME
PROGRAMME SELECTION BUTTON
LEDs