EN 5
of incompatibility between the socket and the appliance plug,
ask a qualified electrician to substitute the socket with another
suitable type. The plug and the socket must be conformed to
the current norms of the installation country. Connection to the
power source can also be made by placing an omnipolar break-
er, with contact separation compliant to the requirements for
overvoltage category III, between the appliance and the pow-
er source that can bear the maximum connected load and that
is in line with current legislation. The yellow-green earth cable
should not be interrupted by the breaker. The socket or omnip-
olar breaker used for the connection should be easily accessi-
ble when the appliance is installed.
The disconnection may be achieved by having the plug accessi-
ble or by incorporating a switch in the fixed wiring in accordance
with the wiring rules.
•
lf the power cable is damaged, it should be substituted with a
cable or special bundle available from the manufacturer or by
contacting the customer service department. The type of pow-
er cable must be H05V2V2-F. This operation should be carried
out by a suitably qualified professional. The earth conductor
(yellow-green) must be approximately 10 mm longer than the
other conductors. For any repairs, refer only to the Customer
Care Department and request the use of original spare parts.
•
Failure to comply with the above can compromise the safety of
the appliance and invalidate the guarantee.
•
Any excess of spilled material should be removed before clean-
ing.
•
A long power supply failure during an occurring cooking phase
may cause a malfunction of the monitor. ln this case contact
customer service.
•
The appliance must not be installed behind a decorative door in
order to avoid overheating.
•
When you place the shelf inside, make sure that the stop is di-
rected upwards and in the back of the cavity. The shelf must be
Summary of Contents for FIDC B100
Page 110: ......
Page 112: ...7001150 0 REV A 07 2022 ...
