Candy CVMAD60/1B/1, Instruction Manual

Page: 8 / 121

9. Equip the inside chimney and outside chimney: Install the outside chimney bracket
on the outside chimney by 2pcs ST4*8mm screws, make sure that the inside chimney
could be moved inside freely, see Pic 6.
10. Fix the chimneys onto the cooker hood:Use 2pcs of ST4*8mm screws to fix the
outside chimney bracket onto the cooker hood bracket,then fix the outside chimney
bracket on the wall by ST4*40mm screws.See Pic 7.
11.
Adjust the height of the inside chimney to the position of the inside chimney bracket
and fix on it by 2pcs ST4*8mm screws. See Pic 8.
Note: The two safety vents are positioned on the back housing, with diameter of 6mm.
HINTS FOR EXHAUST DUCT INSTALLATION
The following rules must be strictly followed to obtain optimal air extraction:
• Keep exhaust duct short and straight
• Do not reduce the size or restrict exhaust duct
• When using flexible duct always install the duct pulled taut to minimize pressure loss
• Failure to observe these basic instructions will reduce the performance and increase
noise levels of the cooker hood.
• Any installation work must be carried out by a qualified electrician or competent
person.
•Do not connect the ducting system of the hood to any existing ventilation system
which is being used for any other appliance ,such as warmer tube, gas tube , hot wind
tube.
•The angle of the bend of the ventilation pipe should not be less than 120º; you must
direct the pipe horizontally, or, alternatively, the pipe should go up from the initial point
and should be led to an outer wall.
7