6
Replacing the mains supply cable
If the mains supply cable is damaged, then it must be replaced by an appropriate
replacement.
The mains supply cable should be replaced in accordance with the following
instructions:
Switch the appliance off at the control switch.
Open the terminal block on the underside of the hob.
Unscrew the terminal screws fixing the cable.
The “green-yellow” earth wire must be connected to
the terminal marked
. It must be about 10 mm
longer than the live and neutral wires.
The “blue” neutral wire must be co nnected to the terminal marked with letter (N) -
the live wire must be connected to the terminal marked with letter (L).
Description of the appliance
1.
front
left hot plate ,Ø190mm
2. panel
3. rear
left
hot plate ,Ø150mm
4.
rear
right hot plate, Ø190mm
5. operating light red
6. rear
left
hot plate control knob
7.
rear
right hot plate control knob
8. front
right
hot plate control knob
9.
front
left heating plate control knob
10. front
right
hot plate, Ø150mm
Operation
Before first use
Remove packaging, clean the interior of the hob.
Switch on the ventilation in the room or open a window.
Important!
The inside of the oven should only be washed with warm water and a small amount of
washing-up liquid.
How to use the hot plate
The level of heat can be adjusted gradually by turning the appropriate knob to the right
or left. Switching on the plate results in a green signal light on the control panel turning
on.
An appropriately selected pan saves energy. A pan should have a thick, flat base with
a diameter equal to the plate diameter as in that case is transferred most efficiently.
