1
Dear Customer,
Thank you for preferring our product. It is very important that you install the cooker hood correctly, so as to use
it for a long time, efficiently and reliability. Please read this User's Manual carefully before installation and using.
1) WHAT TO DO BEFORE USING
1. Please feed your cooker hood with 220 V through a grounded line.
"WE SHALL ASSUME NO RESPONSIBILITY FOR THE LOSSES CAUSED BY UNGROUNDED
LINES"
2. Please connect your cooker hood to chimney outlet where warm gases are discharged and equipment such as
heaters or boilers are connected.
3. Please plug your cooker hood to an earthed socket, while the buttons on the control panel are in off position.
4. Please install the bulb by opening the aluminum cassette filters below your cooker hood.
5. Please install your cooker hood using the instructions within the packing.
6. The distance between the aluminum cassette filter and oven or hob upper surface must be minimum 75cm for
gas ovens, 65 cm for electric ovens.
7. Your cooker hood has been manufactured to offer operation with or without smoke hole connection.
2) CONNECTION TO DUCTING FUNCTION
There is an air discharge outlet on your cooker hood. Please connect the outlet to the chimney outlet, air discharge
or atmosphere, by cutting the glass, using aluminum pipe of 12cm diameter. For the vertical outlets, entry of rain
water into cooker hood should be prevented. Chimney outlet connection will be provided through this hole. For
this purpose, we recommend you to use 120mm diameter pipe with cooker hood. The pipe should be as short as
possible and if possible number of bends. This is important for an efficient operation.
3) RECIRCULATION FUNCTION
Note: If it is necessary to use with recirculation function, you can obtain carbon filter from our authorized dealers.
Please remove the cassette aluminum filter on the cooker hood, by pressing the latches inward, and install the
ACTIVE CARBON FILTER that you have obtained from the service. Your cooker hood is ready to operate with
recirculation mode.
4) INSTALLATION OF THE COOKER HOOD
Use the cooker hood frame to mark upper or back connection holes as well as chimney outlet connection.
(Figure1- Page13)You can see last page of this manuel). Cut chimney outlet hole. Use 4 screws of 3.5x16 YHB to
install the cooker hood onto the kitchen shelf. For the back connection, use an impact drill to open two 7.8mm
diameter, 45mm deep holes and place two dowels of 8mm diameter into these two holes. Screw the L brackets so
as there is 10mm space between them and holes. (Figure2-Page13). Mount your cooker hood to those brackets
through the 2 slots in the back and fix the cooker hood by tightening L brackets. The wall must be intact and
drilled without any damage; otherwise it cannot bear the cooker hood. Connect the aluminum spiral pipe to
complete installation. After installation of inox model hood, please pull up aluminum folio from surface of hood.
5) ELECTRICAL CONNECTION
Connect the cooker hood to a grounded wall outlet which is close enough for the length of the cooker hood cable.
PUSH BUTTON SWITCH USING INFORMATION
The functions of the buttons are as follows:
