FAULT
CAUSE
REMEDY
Warning!
Before removing any panel: 1. Turn the knob to STOP.
2. Pull the electric plug out.
Should the dishwasher fail to operate, before contacting the Service Centre, make
the following checks:
63
FAULT
1 - Machine completely dead
2 - Machine does not
draw water
3 - Machine does not
discharge water
4 - Machine discharge water
continuously
5 - Spray arms are not heard
to rotate
REMEDY
Connect electric plug
Press button
Close door
Check the fuse in the plug and
the electricity supply
Check
Turn water tap on
Turn programme selector to
correct position
Eliminate the bends in the hose
Clean the filter at the end of the
hose
Clean filter
Straighten outlet hose
Follow the instructions for
connecting the outlet hose
carefully
Call a qualified technician
Lift outlet hose to at least 40 cm.
above floor level
Reduce amount of detergent
Use suitable detergent
Check
Clean plate and cup filter
CAUSE
Plug is not connected to wall
socket
O/I button has not been pressed
Door is open
No electricity
See causes for no. 1
Water tap is turned off
Programme selector is not at
correct position
The inlet hose is bent
The inlet hose filter is not correctly
connected
Filter is dirty
Outlet hose is kinked
The outlet hose extension is not
correctly connected
The outlet connection on the wall
is pointing downwards not up-
wards
Position of outlet hose is too low
Excessive amount of detergent
Item prevents arms from ro-
tating
Plate and cup filter very dirty
6 - Load of dishes is only
partially washed
7 - Presence of white spots
on dishes
8 - Noise during wash
9 - The dishes are not
completely dry
Check
Burnt on food remains must
be soaked before putting pans
in dishwasher
Reposition saucepans
Remove spray arms by
unscrewing ring nuts
clockwise and wash under
running water
Do not place the dishes too
closely together
The end of the outlet hose
must not come into contact
with the outflow water
Increase the measure
according to how dirty the
dishes are and change
detergent
Choose a more vigorous
programme
Depress half load button
Check salt and rinse aid level
and regulate amount. Should
the fault persist, Contact
Service Centre
Load dishes better onto the
basket
Load dishes better
Leave the dishwasher door ajar
the end of the wash program to
allow the dishes to dry naturally
62
N.B.: Should any of the situations occur and should the machine give a bad washing performance,
it is necessary to remove the deposits from the dishes by hand since the final drying cycle hardens
the deposits which a second wash in the machine would not be able to remove.
If the malfunction continues contact a Service Centre quoting the serial number of the dishwasher.
This is to found on the plaque on the inside of the dishwasher door at the top or on the guarantee.
This information will make it possible to take more effective action more quickly.
The manufacturers decline any responsability for any printing mistakes in this instruction booklet. They also reserve the right to
modify their own appliances as necessary without altering the essential characteristics.
See causes for no. 5
Bottom of saucepans has not been
washed well
Edge of saucepans has not been
washed well
Spray arms are partially blocked
The dishes have not been
properly loaded
The end of the outlet hose is in
the water
The incorrect amount of
detergent has been measured
out; the detergent is old and hard
The wash programme is not
thorough enough
The lower basket dishes have
not been washed
Water is too hard
The dishes knock against one
another
The revolving arms knock against
the dishes
Indequate air flow
