Canature 95 Series, Installation And Operation Manual

Page: 9 / 28

9
System Start-Up
1. Plug the valve into an approved power source.
2. When power is supplied to the control, the screen will display “Advancing to Service Wait
Please” while it finds the service position.
3. If screen is locked, press MENU for 3 seconds to unlock. Press and hold the SET / REGEN
button for 3 seconds to enter the manual regeneration screen. An option for delayed or
immediate regeneration will appear. Press the DOWN button to select IMMEDIATE.
Press the SET/REGEN button to immediately start moving to the BACKWASH position.
4. Open the inlet on the bypass valve slowly and allow water to enter the unit. Allow all air
to escape from the unit before turning the water on fully then allow water to run to drain
for 3-4 minutes or until all media fines are washed out of the softener indicated by clear
water in the drain hose.
5. Press any button to advance to the BRINE position. Check the water level in the brine
tank to insure the valve is drawing brine properly.
6. Press any button to advance to the RINSE position. Check the drain line flow. Allow the
water to run for 3-4 minutes or until the water is clear.
7. Press any button to advance to the REFILL position. Check that the valve is filling water
into the brine tank. Allow the valve to refill for the full amount of time as displayed on the
screen to insure a proper brine solution for the next regeneration.
8. The valve will automatically advance to the SERVICE position. Open the outlet valve on
the bypass, then open the nearest treated water faucet and allow the water to run until
clear, close the tap and replace the faucet screen.
9. Add salt into the cabinet or brine tank.
10. Program time, date, hardness and people into controller using Programming Instructions
Programming Instructions
Key Pad Configuration
MENU
Enter or exit the system menu. Press and hold the button for 3 seconds to
unlock the screen.
SET/REGEN
Press this button to select a program or to save the settings. Press and hold
the button for 3 seconds to initiate a manual regeneration.
DOWN / UP
Press these buttons to increase or decrease the value of the settings. Press the
buttons to enter the previous or the next menu.
Start-up Instructions