Canature WaterGroup Tannins 89 TLC, Owner'S Manual

Page: 8 / 20

8
Note: As the picture shows, connect the inlet and outlet according to the arrow direction
which seeing from the top view, where you can see the mark of “Up flow” or “Down
flow” on the standard inlet and outlet connector assembly.
The installation of 1“ integrated bypass valve
： ： ： ：
If you use the 1” integrated bypass instead of the three manual valve, the installation
method is showed as the picture below.
1 Use the clips to install the 1” bypass valve between the standard inlet and outlet con-
nector assembly and the inlet and outlet connector, make sure the O-ring is coated
with grease.
2. Connection method of inlet and outlet connector
：
same as the above, make sure to
connect according to the direction of arrow seeing from the top view
；
3. It is also recommended to install the inlet and outlet pressure gauge and the inlet Y-type
filter
；
4. When the two knobs on the bypass valve is parallel, the inlet and outlet are open, this
state of operation is “Service”
；
5. Rotate each of the two knobs in clockwise and anticlockwise respectively, when the
knobs on the bypass is in one line, the inlet and outlet are both closed, this state of op-
eration is “By-pass”.
6. The two small quick connector at the two sides are the sample connection for inlet and
outlet, choose the right elbow connector for taking water samples.