Scentinel Series
Scentinel 1 - Single Carbon Filter Blower
(For use with DFRC-6ES model ONLY)
M-SCT-DFRC6ES_10_11_2022
Page 2 of 2
INSTALLATION
FIGURE 2: BLOWER DISCHARGE & GASKETED CLAMP
FIGURE 3: ALIGNMENT & SECURING SUPPORT BRACKET
For your convenience, the canister support
bracket may be used in several orientations.
Slip the canister through the hole, or use the flat
section to support it (you may need to use zip ties
or other securing hardware not provided).
For a horizontal install, slip canister
through the support bracket.
In the vertical position,
the bracket may be used
to keep the canister from
tipping.
Or by shifting the
bracket over, it can
support the canister
weight.
For a remote install, the
support bracket may be used
to brace the weight. A short
section of the duct & hose
clamp may be needed (not
provided).
FIGURE 1: CANISTER AND POSSIBLE INSTALLATIONS
Intake side
The canister MUST be installed on the
discharge side.
The gasketed clamp slips over the discharge
side, and has two set screws - one for the
blower and one for the filter or duct.
FIGURE 4: FILTER CANISTER INSTALL
3 steel pins on the carbon
filter canister.
Note: The side of the carbon filter canister with 3 pins,
must always be installed in the discharge side of the
blower. Tighten the clamps’ bolt once installed for a
tight seal.
Whether the canister and bracket are
being installed directly, remotely,
vertically or horizontally, always plan
the location and secure the support
bracket in advance.
