GSF SERIES
GALVANIZED SHUTTER FAN - COMPLETE WITH CORD AND PLUG AND PULL CHAIN SWITCH
GSF-M-04_08_22
Page 4 of 11
INSTALLATION INSTRUCTIONS
WARNING
– TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer. If you have questions,
contact the manufacturer.
b) Before servicing or cleaning unit, switch power off at service panel and lock the
service disconnecting means to prevent power from being switched on accidentally.
When the service disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
c) Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards, including fire-rated construction.
d) Sufficient air is needed for proper combustion and exhausting of gases through the
flue (chimney) of fuel burning equipment to prevent back drafting. Follow the heating
equipment manufacturer’s guideline and safety standards such as those published by
the National Fire Protection Association (NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code
authorities.
e) When cutting or drilling into wall or ceiling, do not damage electrical wiring and other
hidden utilities.
1.
The unit should be only securely mounted on the wooden plank.
NOTE:
Allowing the fan frame to flex or move will result in excess vibrations,
which may cause possible premature motor, propeller, or shutter failure.
2.
Install the shutter fan through 8 holes with screws.
(Screws are not included.)
Install a wooden plank
Screws
8 Holes
